4. Disconnect the dial gage, install and tighten the plug to specified torque. (Make sure of a copper washer being attached to the plug) Tighten: Pump rear plug to 17 N m (1.7 kg m/12 lb ft) 5. Release the wax CSD and connect the injection pipe. Tighten: Pipe sleeve nut to 29 N m (3.0 kg m/22 lb ft) If the measured valve is less than the specified limit, above works refer to “TROUBLESHOOTING” Section in this manual. Compression Pressure Measurement 1. Start the engine and allow it to warm up. Engine Coolant Temperature: Above 80 ° C (176 ° F) 2. Stop the engine. 3. Remove the following parts. Quick-On-Start II System Inspection Procedure 1.
Disconnect the thermoswitch connection on the thermostat outlet pipe. 2. Turn the key switch to the “ON” position. If the Quick-ON-Start II system is operating proper- ly, the flow relay will make a clicking sound within three seconds. 3. Measure the glow plug terminal voltage with a cir- cuit tester as soon as possible after turning the key switch to the “ON” position. Glow plugs. In case VE pump; Fuel cut solenoid connector. In case line pump; F-9 fuse in fuse box. 4. Set the adapter and the compression gauge to the No.1 cylinder glow plug hole. Compression Gauge: 5-8840-2675-0 Adapter; Compression Gauge: 5-8531-7001-0 N6A0063E N6A0062E 4. Check the glow plug heating time. 5.
Connect a tachometer and check that engine cranking speed is 200 rpm or higher. 6. Turn the engine over with the starter motor and take the compression gauge reading. 7. Repeat the procedure (steps 4,5 and 6) for the re- maining cylinders. Approximate Glow Plug Heating Time sec 18 Compression Pressure kPa (kg/cm2/psi) at 200 rpm Standard More than 2,942 (30/426) Limit for use 2,157(22/312) Variance in pressure between cylinders Less than 294 (3/43)