N6A0099E N6A0101E 5. Valve Cap Clean Caution: Take sufficient care not to let valve caps fall into the gear case or oil return hole. Cylinder head bolts Cylinder head Carefully remove all varnish, soot and carbon to the bare metal. Do not use a motorized wire brush on any gasket sealing surface. 6. Camshaft Bearing Cap 7. Camshaft Bearing Upper 8. Camshaft Assembly 9. Camshaft Bearing Lower If the camshaft bearings are to be reinstalled, mark their fitting positions by tagging each bearing with the cylinder number from which it was removed. Inspection and Repair Make the necessary adjustments, repairs, and part re- placements if excessive wear or damage is discovered during inspection.
Cylinder head gasket and mating surfaces for leaks, corrosion and blow-by. If the gasket has failed, determine the cause; Improper installation Loose or warped cylinder head Insufficient torque on head bolts Warped case surface 1. Cylinder head bolts for damaged threads or stretching and damaged heads caused by improp- er use of tools. Caution: Suspected bolts must be replaced. 2. Cylinder head for cracks, especially between valve seats and in the exhaust ports. 3. Cylinder head deck for corrosion, sand particles in head and porosity. N6A0100E Caution: Do not attempt to weld the cylinder head. Replace it. 10. Cylinder Head Loosen the cylinder head bolts in numerical order a little at a time.
Cylinder Head Lower Face Warpage Caution: Failure to loosen the cylinder head bolts in numerical or- der a little at a time will adversely affect the cylinder head lower surface. 1. Use a straight edge and a feeler gauge to measure the four sides and the two diagonals of the cylinder head face. 2. If the measured values exceed the specified limit, the cylinder head must be replaced. Refer to Section 6A3 “CYLINDER HEAD”.