Valve Contact Width 1. Check the valve contact faces for roughness and unevenness. Make smooth the valve contact surfaces. 2. Measure the valve contact width. If the measured value exceeds the specified limit, the valve seat insert must be corrected or replaced. N6A0132E Valve Seat Insert Replacement Valve Seat Insert Removal 1. Arc weld the entire inside circumference (1) of the valve seat insert (2). 2. Allow the valve seat insert to cool for a few min- utes. This will invite contraction and make removal of the valve seat insert easier. 3. Use a screwdriver (3) to pry the valve seat insert free. Take care not to damage the cylinder head (4). 4.
Carefully remove carbon and other foreign material from the cylinder head insert bore. Contact Surface Angle on Valve Seat on Valve 1. Measure contact surface angle on valve seat. 2. If the measured value exceeds the limit, replace valve, valve guide and valve seat as a set. N6A0131E Standard Degrees 45 ° N6A0133E Valve Seat Insert Installation 1. Carefully place the attachment (1) (having a small- er outside diameter than the valve seat insert) on the valve seat insert (2). Notice: The smooth side of the attachment must contact the valve seat insert. Valve Contact Width mm (in) Valve Nominal Size Limit Intake 2.5 (0.098) 3.0 (0.118) Exhaust 2.0 (0.079) 2.5 (0.098)