2. Use a bench press (3) to gradually apply pressure to the attachment and press the valve seat insert into place. Valve Seat Angle Degrees 45 ° Caution: Do not apply an excessive amount of pressure with the bench press. Damage to the valve seat insert will result. Notice: Use an adjustable valve cutter pilot. Do not allow the valve cutter pilot to wobble inside the valve guide. N6A0134E 3. The valve should be lapped before final assembly to ensure a good valve seal. Above works refer to “Valve Seat Insert Correction” section in this manual. Valve Seat Insert Correction 1. Remove the carbon from the valve seat insert sur- face. 2.
Use a valve cutter (15 ° , 45 ° , and 75 ° blades) to minimize scratches and other rough areas. This will bring the contact width back to the standard value. Remove only the scratches and rough ar- eas. Do not cut away too much. Take care not to cut away unblemished areas of the valve seat sur- face. N6A0136E 3. Apply abrasive compound to the valve seat insert surface. 4. Insert the valve into the valve guide. 5. Turn the valve while tapping it to fit the valve seat insert. N6A0137E 6. Check to see if the valve contact width is correct. 7. Check to see if the valve seat insert surface is in contact with the entire circumference of the valve. Reassembly N6A0135E 1. Spring Lower Seat