8. Rocker Arm Shaft Inspection and Repair Make the necessary adjustments, repairs, and part re- placements if excessive wear or damage is discovered during inspection. Rocker Arm Shaft Run-Out 1) Place the rocker arm shaft on V-blocks. 2) Use a dial indicator to measure the rocker arm shaft central portion run-out. If the run-out is very slight, correct the rocker arm shaft run-out with a bench press. The rock- er arm must be at cold condition. If the measured rocker arm shaft run-out ex- ceeds the specified limit, the rocker arm shaft must be replaced.
N6A0153E Rocker Arm Bushing Inside Diameter Use either a vernier caliper or a dial indicator to measure the rocker arm bushing inside diameter. N6A0152E Rocker Arm Shaft Outside Diameter Use a micrometer to measure the rocker arm fitting por- tion outside diameter. If the measured value is less than the specified limit, the rocker arm shaft must be replaced. N6A0154E Check to see if the rocker arm oil port is free of obstruc- tions.
Rocker Arm Shaft Run-Out mm (in) Limit 0.3 (0.012) Rocker Arm Bushing mm (in) Inside Diameter Standard Limit 22.010 — 22.035 (0.8665 — 0.8675) 22.15 (0.8720) Rocker Arm and Rocker mm (in) Arm Shaft Clearance Standard Limit 0.010 — 0.056 (0.0004 — 0.0022) 0.2 (0.0079) Rocker Arm Shaft Out- mm (in) side Diameter Standard Limit 21.979 — 22.000 (0.8653 — 0.8661) 21.85 (0.8602)