Isuzu — Isuzu N Series Training Manual

If necessary, use compressed air to clean the rocker arm oil port. Legend 1. Roller 2. Depth gauge Valve Cap Wear Inspect the valve cap surface contacting the rocker arm using a dial gauge. If wear exceeds the limit, replace the valve cap with a new one. N6A0155E Rocker Arm Roller and Rocker Arm Pin 1. Pass a string through the rocker arm-roller clear- ance and measure the roller protrusion while pull- ing both ends of the string in the arrow-indicated directions to push out the roller. 2. Mark the measuring point and draw out the string. Measure the roller protrusion again while the roller is pushed in. 3.

Note the difference in the above measurements is the standard roller-rocker arm pin clearance. Should the clearance exceed the limit, replace the rocker arm. N6A0157E N6A0156E Valve Cap Worn mm (in) Limit 0.1 (0.004) Rocker Arm Roller and mm (in) Pin Clearance Standard Limit 0.040 — 0.084 (0.0016 — 0.0033) 0.5 (0.02)