SERVICE INFORMATION TROUBLESHOOTING Brake System PROBLEM POSSIBLE CAUSE CORRECTION No Brakes 1. Restricted tubing or hose. 2. Brakes out of adjustment. 3. No fluid. 1. Replace defective parts. 2. Adjust. 3. Fill the reservoir with brake fluid. Insufficient Brakes 1. Pedal improperly adjusted. 2. Worn linings/pads or drum/discs. 3. Plugged, crimped, restricted lines or hoses. 1. Adjust. 2. Replace as necessary. 3. Repair or replace. Slow Brake Application 1. Pedal binding. 2. Wheel cylinder piston sticking. 3. Restriction in the lines. 4. Worn linings/pads or drums/discs. 1. Lubricate pivot pin, clean-check for for- eign objects. 2. Repair the wheel cylinder. 3.
Remove the restriction or replace the line. 4. Replace as necessary. Uneven Braking (Front or Rear Brakes not Working) 1. Damaged hydraulic lines. 2. No brake fluid at the master cylinder. 3. Safety valve not opened. 1. Repair or replace. 2. Check for plugged, kinked or damaged hose to the reservoir. 3. Correct. Wet Weather: Brakes Grab or won't Hold 1. Linings too sensitive to water. 2. Dirty brakes. 3. Bent mounting plate - opening. 4. Scored drums/discs. 1. Replace in axle sets. 2. Clean out. 3. Replace. 4. Machine in pairs. Replace if necessary. Brakes Squeak 1. Mounting plate bent or shoes twisted. 2. Metallic particles or dust imbedded in the lining. 3.
Lining rivets loose or lining not held tightly against the shoe at the ends. 4. Drums distorted tampered, or not Square. 5. Incorrect lining/pad. 6. Mixed size linings. 7. Weak or broken return spring. 8. Loose wheel bearings. 9. Loose mounting plate, drum, wheel cyl- inder. 10. Linings/pads located wrong on the shoes. 11. Linings/pads worn out. 12. Lining glazed. 13. Cracked or threaded drums/discs. 1. Replace damaged parts. 2. Replace the linings/pads in axle sets. 3. Replace the rivets and/or tighten the lin- ing by riveting. 4. Machine or replace drums/discs. 5. Replace the linings/pads in axle sets. 6. Use all standard or oversize linings in a brake. 7. Replace the return spring. 8.
Tighten to the proper setting. 9. Tighten. 10. Install the linings correctly. 11. Reline the brakes. 12. Replace. 13. Replace in axle pairs.