Parking Brakes Insufficient Braking Force PROBLEM POSSIBLE CAUSE CORRECTION Weak Braking Action 1. Improperly adjusted or tight exhaust brake valve. 2. Tight linkage. 3. Vacuum lines kinked or partially plugged with ice. 4. Leaking fittings at vacuum lines. 5. Leaky vacuum chamber. 1. Free up and/or adjust. Lubricate as needed. 2. Free up and lubricate. 3. Repair. 4. Tighten. 5. Replace. Exhaust Brake will not Shut Off (Exhaust Brake Control Switch “Off”) 1. Seized exhaust brake valve or linkage. 2. Control valve or chamber jammed with ice. 3. Short in wiring harness (approximate battery(s) voltage) at control solenoid regardless of control switch position. 4. Faulty control switch. 1.
Free up and lubricate. 2. Melt ice and drain lines. 3. Repair. 4. Replace. Exhaust Brake “On” Continuously when Exhaust Brake Control Switch is “On” (not Controlled by Clutch or Accelerator Switches) 1. Improperly adjusted clutch or accelera- tor switches. 2. Switches improperly wired. 3. Short in wiring harness. 1. Adjust. 2. Check wiring against wiring diagram. Repair as needed. 3. Repair. Engine Overheats or Loses Power 1. Engine brake valve stuck partially closed. 2. Engine brake valve adjusted so that it is partially closed. 1. Free up and lubricate or replace. 2. Adjust.
PROBLEM POSSIBLE CAUSE CORRECTION Brake lining and drum clearance Clearance between the brake lining and the brake drum excessive Adjust the brake lining and the brake drum clearance. Brake lining Brake lining worn out Replace the brake lining. Camshaft Camshaft worn out Replace the camshaft. Control wire Control wire stretched Adjust the control wire length or replace the control wire.