Isuzu — Isuzu N Series Training Manual

N6A0586E N6A0587E Legend 1. Washer 2. Snap ring 3. Pilot bearing Ring Gear Inspect the ring gear If the ring gear teeth are broken or excessively worn, the ring gear must be replaced. Ring Gear Replacement 3) Remove the flywheel stopper and the flywheel assembly. 8. Snap Ring Use a snap ring pliers to remove the snap ring from the flywheel. 9. Pilot Bearing REMOVAL Strike around the edges of the ring gear with a hammer and chisel to remove it. Inspection and Repair Flywheel 1. Inspect the flywheel friction surface for excessive wear and heat cracks. 2. Measure the flywheel thickness (t) between the fly- wheel friction surface and crankshaft setting face.

If the measured value is between the standard and the specified limit, the flywheel may be reground. If the measured value exceeds the specified limit, the flywheel must be replaced. N6A0588E INSTALLATION 1. Heat the ring gear evenly with a gas burner to invite thermal expansion. Flywheel Friction Surface Roughness mm (in) Less than 0.006 (0.00024) Flywheel Thickness (t) mm (in) Engine model Standard Limit Others 31.4 — 31.6 (1.236 — 1.244) 31.0 (1.220) 4HG1-TC 37.4 — 37.6 (1.472 — 1.480) 37.0 (1.457)