N6A0589E N6A0586E 2. Install the ring gear when it is sufficiently heated. The ring gear must be installed with the chamfer facing the clutch. Pilot Bearing Check the pilot bearing for wear or damage and replace with a new one if any abnormal condition is noticeable. Legend 1. Washer 2. Snap ring 3. Pilot bearing 4) Remove the crankshaft stopper. 5. Driven Plate Use the clutch pilot aligner to install the driven plate. Clutch Pilot Aligner: 5-8840-2240-0 Installation 1. Pilot Bearing 2. Snap Ring 3. Flywheel Assembly 4. Washer 1) Align the flywheel with the crankshaft knock pin and temporarily tighten the flywheel bolts. 2) Use the crankshaft stopper to prevent the crankshaft from turning.
Crankshaft stopper: 5-8840-2230-0 3) Install the washer and the flywheel bolts and tighten to the specified torque in numerical or- der show in the illustration. Tighten: Flywheel bolt to 1st step: 78 N m (8.0 kg m/58 lb ft) 2nd step: 90 — 120 ° N6A0351E Legend 1. Clutch pilot aligner 2. Clutch pressure plate assembly 3. Driven plate 6. Clutch Pressure Plate Assembly 1) Align the clutch pressure plate with the flywheel knock pin.