N6A0208E N6A1623E 9. Piston and Connecting Rod Assembly 10. Connecting Rod Lower Bearing 11. Connecting Rod Cap Assembly Above works refer to “PISTON AND CONNECT- ING ROD” section in this manual. 12. Oil Pump Assembly 13. Idle Gear A Above works refer to “OIL PUMP ASSEMBLY” section in this manual. 14. Flywheel Houisng 15. Power Steering Pump Idle Gear 16. Power Steering Pump Idle Gear Cover 17. Oil Thermo Valve Above works refer to “TIMING GEAR REPLACE- MENT” section in this manual. 18. Front Retainer 1) Carefully wipe any foreign material from the cyl- inder body front face.
2) Apply 2.5 — 3.5 mm (0.10 — 0.14 in) bead of the recommended liquid gasket (Three Bond 1207C) or its equivalent on the groove of the front retainer fitting surface shown in the illus- tration. 3) Install the O-rings (2 pieces) to the front retain- er. Legend 1. O-ring 2. Liquid gasket N6A0234E 19. Water Pump Assembly 1) Apply 3 — 4 mm (0.12 — 0.16 in) bead of the recommended liquid gasket (Three Bond 1207C) or its equivalent on the water pump fit- ting surface. 2) Install the water pump to the front retainer. Install the front retainer within 7 minutes after application of liquid gasket. For the dislocation of liquid gasket, refer to the illustration.
4) Align the cylinder body knock pins with the front retainer knock pin holes. Tighten: Water pump bolt to 24 N m (2.4 kg m/17 lb ft) Tighten: Front retainer bolt to 24 N m (2.4 kg m/17 lb ft) Install the water pump within 7 minutes after application of liquid gasket. For the dislocation of liquid gasket, refer to the illustration. Caution: The water pump clamping bolt is also used to tighten the front retainer. So, install the water pump before liquid