Isuzu — Isuzu N Series Training Manual

gasket gets dry immediately after installation of the front retainer. N6A0657E N6A1625E 22. Oil Pan 23. Spacer Rubber Above works refer to “OIL PAN” section in this manual. 24. Crankshaft Rear Slinger 25. Crankshaft Rear Oil Seal Above works refer to “CRANKSHAFT REAR OIL SEAL” section in this manual. 26. Flywheel 1) Align the flywheel with the crankshaft knock pin and temporarily tighten the flywheel bolts. 2) Use the crankshaft stopper to prevent the crankshaft from turning. Crankshaft Stopper: 5-8840-2230-0 3) Install the washer and the flywheel bolts and tighten to the specified torque in numerical or- der show in the illustration. Legend 1. Liquid gasket 20. Water Pump Pulley Tighten:

Water pump pulley bolt to 24 N m (2.4 kg m/17 lb ft) Tighten: Flywheel bolt to 1st step: 78 N m (8.0 kg m/58 lb ft) 2nd step: 90 — 120 ° N6A0656E Legend 1. Pulley 2. Set plate 21. Oil Pump Strainer Install the O-ring (1) to the oil pump strainer pipe and install the oil pump strainer to the cylinder body shown in the illustration. Tighten: Oil pump strainer bolt to 24 N m (2.4 kg m/17 lb ft)