Isuzu — Isuzu N Series Training Manual

2) Tighten the check valves and oiling jets to the specified torque. 4. Thrust Bearing Upper Install the thrust bearing upper to the front side of the cylinder body No.5 journal. At this time, the thrust bearing upper may be pasted to the cylinder body with grease. However, be sure to wipe off nay excessive grease. Tighten: Check valve and oiling jet to 21 N m (2.1 kg m/15 lb ft) Caution: The thrust bearing oil grooves must be facing the sliding faces. N6A0700E 3. Crankshaft Bearing Upper When replacing the crankshaft or the crankshaft bearing with a new one, select the crankshaft bear- ing according to the respective grades stamped on the crankshaft and the cylinder body.

Refer to the “CRANKSHAFT” in section 6A. All upper bearings have oil grooves. N6A0648E 5. Crankshaft Assembly Apply an ample coat of engine oil to the crankshaft journals and the crankshaft bearing surfaces be- fore installing the crankshaft with timing gear. N6A0647E 1) Carefully wipe any foreign material from the up- per bearing. Caution: Do not apply engine oil to the bearing back faces and the cylinder body bearing fitting surface. N6A0649E 6. Crankshaft Bearing Lower All lower bearings does not have oil grooves. 1) Carefully wipe any foreign material from the lower bearing. 2) Locate the position mark applied at disassem- bly if the removed upper bearings are to be re- used.