Caution: Do not apply engine oil to the bearing back faces and the crankcase bearing fitting surfaces. 2) Locate the position mark applied at disassem- bly if the removed lower bearings are to be re- used. 7. Thrust Bearing Lower Install the thrust bearing lower to the rear side of the crankcase No.5 journal. Caution: The thrust bearing oil grooves must be facing the sliding faces. N6A0650E 8. Crankcase 1) Apply a 3 mm (0.12 in) bead of recommended liquid gasket (Three Bond 1207C) or its equiv- alent to the crankcase upper surface as shown in the illustration. 2) Carefully place the crankcase on the cylinder body. Install the crankcase within 20 minutes after application of liquid gasket.