N6A0208E N6A0439E 9. Piston and Connecting Rod Assembly 10. Connecting Rod Bearing 11. Connecting Rod Cap Above works refer to “PISTON AND CONNECT- ING ROD” section in this manual. 12. Oil Pump Assembly Above works refer to “OIL PUMP ASSEMBLY” section in this manual. 13. Idle Gear B Shaft 15. Idle Gear A 1) Turn the crankshaft clockwise so that the en- gagement mark of the crankshaft gear faces to the shaft center of the idle gear A and the No.1 cylinder piston comes to the top dead center. 2) Align the crankshaft gear with the engagement mark of the idle gear and install the idle gear A. Tighten: Idle gear A bolt to 133 N m (13.6 kg m/98 lb ft) Tighten:
Idle gear B shaft bolt to 31 N m (3.2 kg m/23 lb ft) Apply the engine oil to the idle gear shaft after in- stallation. N6A0440E N6A0438E 14. Idle Gear B The face of the idle gear B with longer boss should be positioned toward the rear side shown in the il- lustration Tighten: Idle gear B bolt to 110 N m (11.2 kg m/81 lb ft)