N6A0711E N6A0181E 16. Flywheel Housing 1) Carefully wipe any foreign material from the cyl- inder body rear face. 2) Apply the recommended liquid gasket (Three Bond 1207C) or its equivalent to the shaded ar- eas shown in the illustration. Tighten the bolts marked with “E” or “B” from the injection pump side, and those with “F” from the cylinder body side. Tighten: Flywheel housing bolt (G) to 96 N m (9.8 kg m/71 lb ft) N6A0180E N6A0182E 3) Align the cylinder body knock pins with the fly- wheel housing knock pin holes. 4) Tighten the flywheel housing bolts to the spec- ified torque shown in the illustration. 17. Power Steering Pump Idle Gear 1) Apply the engine oil to the idle gear shaft.
2) Install the idle gear shaft (1) with the idle gear (2) to the cylinder body A portion as shown in the illustration. Tighten: Flywheel housing bolt to (A): 96 N m (9.8 kg m/71 lb ft) (B): 48 N m (4.9 kg m/35 lb ft) (C): 94 N m (9.6 kg m/69 lb ft) (D): 25 N m (2.6 kg m/19 lb ft) (E): 76 N m (7.7 kg m/56 lb ft) (F): 48 N m (4.9 kg m/35 lb ft) Tighten: Idle gear shaft bolt to 133 N m (13.6 kg m/98 lb ft)