Legend 1. O-ring 2. Liquid gasket N6A0641E 21. Front Retainer 1) Carefully wipe any foreign material from the cyl- inder body front face. 2) Apply a 2.5 — 3.5 mm (0.10 — 0.14 in) bead of the recommended liquid gasket (Three Bond 1207C) or its equivalent on the groove of the front retainer fitting surface shown in the illus- tration. 3) Install the O-rings (2 pieces) to the front retain- er. N6A0234E 22. Water Pump Assembly 1) Apply 3 — 4 mm (0.12 — 0.16 in) bead of the recommended liquid gasket (Three Bond 1207C) or its equivalent on the water pump fit- ting surface. 2) Install the water pump to the front retainer.
Install the front retainer within 7 minutes after application of the liquid gasket. Tighten: Water pump bolt to 24 N m (2.4 kg m/17 lb ft) For the dislocation of liquid gasket, refer to the illustration. 4) Align the cylinder body knock pins with the front retainer knock pin holes. Install the water pump within 7 minutes after application of liquid gasket. Tighten: Front retainer bolt to 24 N m (2.4 kg m/17 lb ft) For the dislocation of liquid gasket, refer to the illustration. Caution: The water pump clamping bolt is also used to tighten the front retainer. So, install the water pump before liquid gasket gets dry immediately after installation of the front retainer. N6A1623E