Isuzu — Isuzu N Series Training Manual

N6A1625E N6A0657E Legend 1. Liquid gasket 25. Oil Pan Above works refer to “OIL PAN” section in this manual. 26. Spacer Rubber Above works refer to “OIL PAN” section in this manual. 27. Crankshaft Rear Slinger 28. Crankshaft Rear Oil Seal Above works refer to “CRANKSHAFT REAR OIL SEAL” section in this manual. 29. Flywheel Assembly 1) Align the flywheel with the crankshaft knock pin and temporarily tighten the flywheel bolts. 2) Use the crankshaft stopper to prevent the crankshaft from turning. Crankshaft Stopper: 5-8840-2230-0 3) Install the washer and the flywheel bolts and tighten to the specified torque in the numerical order show in the illustration. 23. Water Pump Pulley Tighten:

Water pump pulley bolt to 24 N m (2.4 kg m/17 lb ft) Tighten: Flywheel bolt to 1st step: 78 N m (8.0 kg m/58 lb ft) 2nd step: 90 — 120 ° N6A0656E Legend 1. Pulley 2. Set plate 24. Oil Pump Strainer Install the O-ring (1) to the oil pump strainer pipe and install the oil pump strainer to the cylinder body shown in the illustration. Tighten: Oil pump strainer bolt to 24 N m (2.4 kg m/17 lb ft)