1207C) or its equivalent on the groove of the water suction pipe fitting surface. 2) Install the water suction pipe to the oil cooler. Tighten: Heater pipe bolt to 24 N m (2.4 kg m/17 lb ft) For the dislocation of liquid gasket, refer to the illustration. N6A0290E N6A1627E Legend A. 4HF1-2 Legend 1. Liquid gasket 39. Idle Pulley Bracket (If equipped with A/C) Tighten: Idle pulley bracket bolt to 48 N m (4.9 kg m/35 lb ft) Tighten: Water suction pipe bolt and nuts to 24 N m (2.4 kg m/17 lb ft) Notice: Install the water suction pipe immediately after the in- stallation of the oil cooler. N6A0289E 40. Injection Pump Rubber Spacer 41.
Injection Pump Assembly Above works refer to “INJECTION PUMP ASSEM- BLY” section in this manual. 42. Engine Foot N6A0322E Tighten: Engine foot bolt to 51 N m (5.2 kg m/38 lb ft) 38. Heater Pipe 1) Install the O-ring to the heater pipe. 2) Install the heater pipe to the oil cooler.