It is advisable to flash the interior of the cooling system including the radiator before using anti-freeze (ethylene- glycol based). Replace damaged rubber hoses as the engine anti- freeze coolant is liable to leak out even minor cracks. Isuzu recommends to use Isuzu genuine anti-freeze (ethylene-glycol based) or equivalent, for the cooling system and not add any inhibitors or additives. 10. When the engine has been cooled, check filler neck for water level and replenish if required. Should extreme shortage of coolant is found, check the coolant system and reservoir tank hose for leakage. 11. Fill the coolant into the reservoir tank up to “MAX” line. Water Pump Caution:
A failure to correctly fill the engine cooling system in changing or topping up coolant may sometimes cause the coolant to overflow from the filler neck even before the engine and radiator are completely full. If the engine runs under this condition, shortage of cool- ant may possibly result in engine overheating. To avoid such trouble, the following precautions should be taken in filling the system. 3. To refill engine coolant, pour coolant up to filler neck using a filling hose which is smaller in outside diameter of the filler neck. Otherwise air between the filler neck and the filling hose will block entry, preventing the system from completely filling up. 4.
Keep a filling rate of 9 liter/min or less. Filling over this maximum rate may force air inside the engine and radiator. And also, the coolant overflow will increase, mak- ing it difficult to determine, whether or not the sys- tem is completely full. 5. After filling the system to the full, pull out the filling hose and check to see if air trapped in the system is dislodged and the coolant level goes down. Should the coolant level go down, repeat topping- up until there is no more drop in the coolant level. 6. After directly filling the radiator, fill the reservoir to the maximum level. 7. Install and tighten radiator cap and start the en- gine.
After idling for 2 to 3 minutes, stop the engine and reopen radiator cap. If the water level is lower, replenish. The coolant pump is a centrifugal impeller type and is driven by V type drive belt. N6A0790E Thermostat The thermostat is a wax pellet type with a jiggle valve and is installed in the outlet pipe. WHEN THE COOLANT IS HEATED TO A HIGH TEM- PERATURE, BE SURE NOT TO LOOSEN OR RE- MOVE THE RADIATOR CAP. OTHERWISE YOU MIGHT GET SCALDED BY HOT VAPOR OR BOILING WATER. TO OPEN THE RADIATOR CAP, PUT A PIECE OF THICK CLOTH ON THE CAP AND LOOS- EN THE CAP SLOWLY TO REDUCE THE PRESSURE WHEN THE COOLANT HAS BECOME COOLER. 8.
After tightening radiator cap, warm up the engine at about 2,000 rpm. Set heater adjustment to the highest temperature position, and let the coolant circulate also into heat- er water system. 9. Check to see the thermostat has opened through the needle position of water thermometer, conduct a 5-minute idling again and stop the engine. N6A0791E Legend A. Without jiggle valve WWaArRnNinIgN:G: