Isuzu — Isuzu N Series Training Manual

Leakage Hold the tester handle to about 2,070 kPa (21 kg/cm 2 / 300 psi) below the opening pressure. If no drops of fuel fall from the nozzle tip within 10 seconds, the nozzle is not leaking. Chatter An easily audible chatter at all pump lever speeds should be heard. TEST FLUID FROM THE INJECTION NOZZLE WILL SPRAY OUT UNDER GREAT PRESSURE. IT CAN EASILY PUNCTURE A PERSON’S SKIN. KEEP YOUR HANDS AWAY FROM THE INJECTION NOZ- ZLE TESTER AT ALL TIMES. Disassembly Clamp the injection nozzle holder in a vice. N6A0846E 3. Injection Nozzle Keep the nozzle along with the needle valve sepa- rately to maintain the original nozzle to needle valve combination. 4. Spacer 5. Spring Seat 6. Nozzle Spring 7.

Adjusting Shim Keep the adjusting shims in the original groups to hold the initial shim to nozzle spring combination. 8. Nozzle Holder Body Caution: Wash all the parts removed and arrange them on a cylinder basis, care should be taken not to miss any parts. Soak the nozzle assembly in a parts receptacle filled with light oil. N6A0845E Care should be taken not to miss shim, if used. Legend 1. Flange 2. Retaining nut 3. Injection nozzle 4. Spacer 5. Spring seat 6. Nozzle spring 7. Adjusting shim 8. Nozzle holder body 1. Flange 2. Retaining Nut Use a wrench to remove the injection nozzle retain- er nut. N6A0847E WWaArRnNinIgN:G: