Isuzu — Isuzu N Series Training Manual

Legend 1. TDC 3) Align the injection pump bracket slit with the timer slit. 4) Install the injection pump assembly to the cylin- der body. Notice: When the injection pump has a poor gear engagement while installing the assembly to the cylinder body, insert a screwdriver into the slit on the time peripheral with the pump bracket slit used as a guide, and move it up and down to get it into forcibly. N6A0908E Legend 1. Pointer 2. Timer outside mark 3. Timing check hole For 4HE1-TC N6A0907E 5) After installing the injection pump, the injection timing can be checked through the timing check hole provided at the injection pump bracket.

Set the No.1 cylinder to the BTDC (injection timing of engine mode) on the compression stroke. When the pointer of the timing check hole comes in line with the mark on the timer periphery of the injection pump as shown in the illustration, the injection timing is normal. After completion of the injection timing check, tighten the check hole plug to the specified torque. N6A0909E Legend 1. 8 ° mark 2. Pointer 3. 13 ° mark 4. Timing check hole 6) Turn the crankshaft until the timing mark on the crankshaft damper pulley is aligned with “8 ° (98EPA) or “9 ° ” (Spec EURO3) line. Notice: Position in its normal rotating direction. (for 4HE1-TC only) Injection Timing deg 4HF1:

4HE1-TC (4HE1-XS, XN) BTDC 8 4HG1 BTDC 9 4HG1-T BTDC 7 BTDC 9 (For Colombia) 4HE1-TC (4HE1-XS) BTDC 9 (Spec EURO3)