8) Tighten the injection pump bracket nuts and bolts to the specified torque. Tighten: Injection pump bracket nut and bolt to 48 N m (4.9 kg m / 35 lb ft) N6A0910E Legend 1. TDC 7) Adjust injection pump downward so that the ° ” (98EPA) or “9 ° ” (Spec EURO3) comes to position in the timing check hole. (for 4HE1-TC only) N6A0912E 9) Install the injection pump rear bracket. Tighten: Injection pump rear bracket bolt to 48 N m (4.9 kg m / 35 lb ft) Notice: Whenever the injection pump is replaced, be sure to ad- just the injection timing. For the details of the adjust- ment, refer to the “SECTION 00 SERVICING: INJECTION TIMING INSPECTION AND ADJUST- MENT”. 10)Install the inspection hole plug.
Tighten: Inspection hole plug to 48 N m (4.9 kg m / 35 lb ft) Notice: In case the crank pulley has two marks as illustrated, (1) BTDC 49 ° mark on the second crest and (2) TDC mark on the third crest (as viewed from the front side), be sure to set at the mark (2). (If there are two different marks on one and same crest, set at the mark which comes sec- ond when rotated in the normal direction.) The mark (1) is used when installing the injection pump for 4HF1-2. N6A0911E Legend 1. 8 ° mark 2. Pointer 3. 13 ° mark 4. Timing check hole