Isuzu — Isuzu N Series Training Manual

Some tang locks are released by pulling them towards you. Other tang locks are released by pressing them forward. Determine which type of tang lock is on the connector being handled. Firmly grasp both sides (male and female) of the con- nector. Release the tang lock and carefully pull the two halves of the connector apart. N6A1108E Connector Inspection Use a circuit tester to check the connector for continuity. Insert the test probes from the connector wire side. N6A1106E Never pull on the wires to separate the connectors. This will result in wire breakage. N6A1109E Legend 1. Test probe Never insert the circuit tester test probes into the con- nector open end to test the continuity.

Broken or open connector terminals will result. N6A1107E Connecting the Connector Firmly grasp both sides (male and female) of the con- nector. Be sure that the connector pins and pin holes match. Be sure that both sides of the connector are aligned with each other. Firmly but carefully push the two sides of the connector together until a distinct click is heard.