2. Push the tang lock up (in the direction of the arrow in the illustration). Pull the wire with pin free from the wire side of the connector. N6A1110E Legend 1. Test probe N6A1112E Waterproof Connector Inspection It is not possible to insert the test probes into the con- nector wire side of a waterproof connector. Use one side of a connector (1) with its wires cut to make the test. Connect the test connector (2) to the con- nector to be tested. Connect the test probes to the cut wires to check the connector continuity. Legend 1. Slender shaft 2. Housing open pad 3. Pin 4. Tang lock 5. Wire Pin Tang Lock Type 1. Insert a slender shaft into the Connector housing open end. 2.
Push the tang lock flat (toward the wire side of the connector). Pull the wire with pin free from the wire side of the connector. N6A1111E Legend 1. Connector 2. Test connector 3. Test probe Connector Pin Removal Connector Housing Tang Lock Type 1. Insert a slender shaft into the connector housing open end. N6A1113E