SERVICING Service Brakes D2L Wheel Brake Adjustment Brake Lining Clearance Adjustment (2L and D2L) Without auto-adjuster type 1. Chock the wheels not being adjusted. 2. Jack up the axle until the wheels can be turned freely. 3. Manually shake the wheel to check for excessive play. 4. Remove the grommet fitted to one of the brake drum cover adjuster holes. 5. Insert a screwdriver into the adjuster hole. Manually rotate the wheel while turning the adjust- er (A) in the direction of the arrow (1) until resis- tance is felt at the wheel. 6. Back off the adjuster (A) in the direction of the ar- row (2) the specified number of notches. N5A0002E 7. Install the grommet to the adjuster hole. 8.
Repeat Steps 4 through 7 on the other wheels. 9. Lower the vehicle to the ground. 2L With auto-adjuster type 1. Measure the internal diameter of the brake drum. Take measurement of the distance at (A), (B) and (C) points. N5A0001E N5A0003E 2. Measure the external diameter of the brake shoe. Take measurement of the distance at (A), (B) and (C) points. Specified Notches Front Rear 5-6