N5A0012E Brake Bleeding Procedure Bleed the brake hydraulic circuit in the following se- quence. LHD Left-hand rear wheel (vehicle equipped with ABS) Right-hand rear wheel DSPV or LSPV (If so equipped) Right-hand front wheel Left-hand front wheel RHD Left-hand rear wheel (vehicle equipped with ABS) Right-hand rear wheel DSPV or LSPV (If so equipped) Left-hand front wheel Right-hand front wheel N5A0011E Legend A. Pedal travel (Reference).....180 ± 5 mm (7.09 ± 0.2 in) B. Pedal height (Reference).....167 mm (6.58 in) Brake Bleeding Brake Bleeding Precautions Air in the brake hydraulic circuit will result in dangerous reduced braking efficiency.
The brake hydraulic circuit must be bled whenever the vehicle has been operated with the reservoir brake fluid level at an excessively low level or any time the brake pipes have been disconnected in the course of brake servicing. The brake bleeding procedure requires the cooperative action of two men. N5A0013E 1. Check to make sure that the service area is well ventilated. Apply the parking brake firmly. Start the engine and allow it to run until the vacuum pressure rises suf- ficiently. Notice: Brake booster (master-vac) will be adversely effected if bleeding operation is performed without running engine.