Isuzu — Isuzu N Series Training Manual

N5A0008E N5A0010E Hydraulic Booster Type Legend 1. Accumulator 2. Stud bolt 3. Cover boss 4. Lock nut 5. Clevis 6. Operating rod 7. Guard 8. Flange Push Rod Length Use a scale to measure the push rod length (push rod to flange face clearance). Push Rod Length “L” to 17.95 — 18.2 mm (0.707 — 0.717 in). If the push rod length is not equal to the specifica- tion, the hydraulic booster assembly must be re- placed. 4. Tighten the operating rod jam nut. Tighten: Jam nut to 20 N m (2.0 kg m / 14 lb ft) 5. Stop light switch so that the end of the switch threaded portion contacts the brake pedal, then back off the switch 1/2 turn. Tighten: Stop light switch locknut to 20 N m (2.0 kg m / 14 lb ft) 6.

Check light pedal operation to be sure that it is op- erating properly. Measure the brake pedal free play, after reduc- ing the pressure of the hydraulic oil in the accu- mulator by pedal operations at least 10 times with engine off. Brake pedal normal play is between 21 — 24 mm (0.83 — 0.94 in). N5A0009E Operating Rod Length 1. Loosen the jam nut at the stop light switch. 2. Loosen the jam nut on the hydraulic booster oper- ating rod. 3. Turn the operating rod until the distance from the center of clevis pin hole to mounting surface of the brake pedal bracket should be set at 109 ± 1 mm (4.29 ± 0.04 in).

When fixed under this condition, there is no need to adjust the brake pedal height and free play. Pressing the brake pedal with a force of 294 N (30 kg / 66 lb) with the engine on, the clearance between the brake pedal and floor panel is more than 35 mm (1.4 in). Brake pedal height “B” is 167 mm (6.58 in) (ref- erence). Brake pedal travel “A” is between 180 ± 5 mm (7.09 ± 0.2 in) (reference).