the work, first turn the engine off, wait 30 minutes, and verify that the temperature has cooled off. 4. Even when a long time passes after the engine is turned off, the high-pressure hydraulic oil in the ac- cumulator of the hydro boost remains stored under pressure. Before removing the hydro boost assembly or pip- ing, be sure to repeatedly press the brake pedal at least ten times with the engine off, and make sure the pressure of the hydraulic oil in the accumulator has been reduced to atmospheric pressure before doing the work.
In particular, when removing the replacement-part accumulator from the hydro boost assembly, the hydraulic oil may spatter if it remains stored under high pressure inside the accumulator, so be careful of this. Parking Brake N5A0024E Parking Brake Adjustment Parking Brake Lining Clearance Adjustment 1. Jack up the rear axle until the wheels can be turned freely. Before beginning to adjust the parking brake, park the vehicle on a level surface, chock all of the wheels, and place the parking brake lever in the released (off) posi- tion. Then loosen the parking brake control wire lock nut (1), and turn the adjuster (2) to completely loosen the park- ing brake control wire. N5A0021E 2.
Remove one of the two check hole covers from the parking brake drum. 3. Rotate the brake drum to align the check hole with the adjusting screw. 4. Move the camshaft lever from side to side several times to center the brake shoes. 5. Insert a screwdriver into the check hole and rotate the adjusting screw by pushing it upward. Continue doing this until the brake shoes begin to drag on the drum. N5A0020E