4. Disassembly, Inspection and Reassembly of Engines Point6: Piston pin and rings [Disassemble] z Using the piston ring replacer (see 4.1.2 in Chapter 4), remove the piston rings. z Remove the circlip and remove the piston pin by pushing it out. [Reassemble] z Install each piston ring on the piston, with the punched manufacturer’s mark facing upward. [Reassemble] z The piston ring joints shall be staggered at by 120 ° intervals. Do not position the top ring joint vertical to the piston pin. The coil expander joint shall be opposite to the oil ring joint.
[Reassemble] z When installing the piston pin to the rod and piston, the punched match mark on the big end of the connecting rod shall be opposite to the size mark on the piston top. [Reassemble] z Install the piston in the cylinder clock with the punched mark on the big end of the rod on the nozzle side. (The embossed mark at the connecting rod I-beam section shall be on the flywheel side.) 94