4. Disassembly, Inspection and Reassembly of Engines 4.4.5 Parts inspection and measurement (1) Cylinder block Especially clean head surface, cylinder bores and oil holes, and check after removing any carbon deposit and bonding agent. (a) Appearance inspection Check if there is any discoloration or crack. If crack is suspected, perform color check. Sufficiently clean the oil holes and check they are not clogged. (b) Cylinder bore and distortion Measure at 20 mm below the crest of the liner, at 20 mm from the bottom end and at the center. Roundness: Roundness is found as follows though it is the simple method.
Measure cylinder diameters of the A direction and the B direction on each section of a, b and c. Roundness is the maximum value among those difference values. Cylindricity: Cylindricity is found as follows though it is the simple method. Measure cylinder diameters of a, b and c sections in the A direction, and calculate the difference in maximum value and minimum value of the measured diameters. In the same way measure and calculate the difference in the B direction. Cylindricity is the maximum value between those difference values.
mm 95 Item Model Standard Limit Cylinder inside diameter 3TNV82A 82.000 82.030 82.200 TNV84 84.000 84.030 84.200 TNV88 88.000 88.030 88.200 4TNV94L 94.000 94.030 94.130 4TNV98 98.000 98.030 98.130 4TNV106(T) 106.000 106.030 106.130 Cylinder bore Roundness all TNV 0.01 or less 0.03 Cylindricity