4. Disassembly, Inspection and Reassembly of Engines (2) Crankshaft Mainly check seizure and wear of the crankpins and journals. Since the crankshaft gear is shrink-fitted, heat to 180 to 200 when extraction is necessary. (a) Shaft portion color check After washing the crankshaft, inspect it by means of color check or a magnaflux inspector. Replace it if cracked or heavily damaged. Slight defects shall be corrected by grinding. (b) Crankshaft bend Support the crankshaft journals at both ends with V-blocks. Use a dial gage and measure the runout at the center journal while rotating the shaft to inspect the bend.
(c) Crankpin and journal measurement Measure the outside diameter, roundness and taper at each crankpin and journal. Correct by grinding if unevenly wear, roundness exceeding the limit or insufficient outside diameter is found. Replace if the defect is excessive. 97 Limit 0.02mm or less