Komatsu — 4.4.6 Cylinder bore correction

4. Disassembly, Inspection and Reassembly of Engines (6) Tappet Mainly check the tappet contact surface with the cam and push rod. Slight surface defects shall be corrected with an oilstone. (a) Tappet stem outside diameter measurement mm 4.4.6 Cylinder bore correction 1) Slight uneven worn, flawed, etc. shall be corrected by honing only. If the cylinder is unevenly worn partially, flawed or otherwise damaged and cannot be repaired simply by honing, rebore the cylinder first and then hone. See 4.4.5.(1)(c) for the boring dimension.

2) Items to be prepared for honing z Flex-Hone (see No.8 of 4.1.2 in Chapter 4) z Electric drill z Honing fluid (50:50 mixture of lube oil and diesel oil) 106 Model Item Standard Limit TNV82A 88 Tappet hole I.D. 12.000 12.025 12.045 Stem O.D. 11.975 11.990 11.955 Clearance 0.010 0.050 0.090 4TNV94L 98 Tappet hole I.D. 12.000 12.018 12.038 Stem O.D. 11.975 11.990 11.955 Clearance 0.010 0.043 0.083 4TNV106(T) Tappet hole I.D. 14.000 14.018 14.038 Stem O.D. 13.966 13.984 13.946 Clearance 0.015 0.052 0.092