Komatsu — 4.4.5 Parts inspection and measurement

4. Disassembly, Inspection and Reassembly of Engines (d) Rod big end measurement Measure the crankpin and bushing according to 4.4.5.(2)(c) described above. Calculate the oil clearance of a crank pin metal and a crank pin from the measured values of the crank pin metal inner diameter and the crank pin outside diameter. Replace a crank pin metal if the oil clearance becomes about the limit dimension of the below table. Correct by grinding if unevenly wear, roundness exceeding the limit or insufficient outside diameter is found. Also use an undersized metal.

(Refer to the above (2) c.) [NOTICE] When measuring the inside diameter of the rod big end, install the crankpin metals in the rod big end not to mistake the top and bottom of the metals and tighten the rod bolts by the standard torque. Tightening torque of rod bolt Standard of rod big end mm 105 Model Tightening torque Nm(kgf-m) Lubricating oil application (threaded portion, and bearing seat surface) 3TNV82A 37.2 41.2 (3.8 4.2) Lube. oil applied TNV84/88 44.1 49.0 (4.5 5.0) 4TNV94L/98 53.9 58.8 (5.5 6.0) 4TNV106(T) 78.5 83.4 (8..0 8.5) Model Item Standard Limit 3TNV82A Rod I.D. bushing 42.952 42.962 42.902 Crankpin O.D.

43.000 43.042 - Metal thickness 1.487 1.500 - Clearance 0.038 0.090 0.150 TNV84/88 Rod I.D. bushing 47.952 47.962 47.902 Crankpin O.D. 48.000 48.026 - Metal thickness 1.492 1.500 - Clearance 0.038 0.074 0.150 4TNV94L/98 Rod I.D. bushing 57.952 57.962 57.902 Crankpin O.D. 58.000 58.026 - Metal thickness 1.492 1.500 - Clearance 0.038 0.074 0.150 4TNV106(T) Rod I.D. bushing 63.952 63.962 63.902 Crankpin O.D. 64.016 64.042 - Metal thickness 1.984 1.992 - Clearance 0.054 0.090 0.150