8. Turbochager (b) Measuring instruments and devices (c) Check method 1) Set the manometer control pressure (Pc) applied to the waste gate actuator to 0 and set the dial gage to the zero point. 2) Gradually open the pressure regulating valve and measure the Pc value when the actuator rod is operated by 2 mm. 3) For the hysteresis, let the rod move to 3 mm first. The gradually close the pressure regulating valve, measure the pressure when the rod is moved to 2mm and obtain the difference from the pressure measured in b. above. 4) Precautions z Set the dial gage on the extension line of the actuator rod. z The piping and joints shall completely be free from leak.
z Fix the turbocharger and dial gage securely. z If an electric manometer is used, it shall have sufficient precision. z Even when an electric manometer is used, use of a mercury column type manometer in combination is recommended for calibration and daily check. z The speed for increasing/decreasing Pc by means of the pressure regulating valve shall be very slow near the measuring point. If the mm position is exceeded, restart from the beginning. z Do not apply over 0.49 MPa (5 kgf/cm 2 ) to the actuator. (2) Waste gate actuator leak test Apply 0.12 Mpa (1.2kgf/cm 2 ) to the actuator and hold the state for minute.
The actuator is good if the pressure then is 0.11 Mpa (1.1kgf/cm 2 ) or above. 126 Dial gage Capable of measuring 0 to 10 mm (A flat head type is recommendable.) Manometer Mercury column or electrical type (capable of measuring 0 to 1500 mmHg) Pressure regulating valve Allowing gradual adjustment in a range between 0 and 2 kgf/cm2 (0.196 Mpa) Pressure reducing valve Used for suppressing the air supply pressure at 5 kgf/cm2 (0.49 Mpa) or less. Pressure gage Bourdon tube pressure gage (0 to 10 kgf/cm2 (0.98 Mpa))