Komatsu — 8.4.1 Preparation for disassembly

8. Turbochager 8.4 Disassembly Procedure 8.4.1 Preparation for disassembly In addition to the general tools, the following special tools are required for turbocharger disassembly and reassembly: 127 Tool name Use Illustration Bar For removing thrust bearing and thrust bushing Material: Copper or brass Pliers For removing floating bearing circlip Pliers For removing seal ring Torque driver for TORX bolt (multifunctional type) 0.5 to 4.9N-m (5 to 50 kgf-cm) For thrust bearing installation (for M3):1.3 N-m (13 kgf-cm) For seal plate installation (for M3):1.3 N-m (13 kgf-cm) Item sold on market (Type:

TORX TT20 or equivalent) Box wrench For fixing turbine shaft (mm dodecagonal) Box only may be used. Torque wrench (single purpose) For following bolts and nuts: M8:mm, kgf-cm(N-m) M5:mm, kgf-cm(N-m) M5:mm, kgf-cm(N-m) Probe For measuring play in axial and radial directions: To be installed on a dial gage