8. Turbochager (6) Thrust bushing, oil thrower 2 and thrust bearing 6 Inspect each part for wear, surface defect and discoloration. Replace with a new one if defective even within the wear limit. (a) Thrust bushing Measure the distance between grooves (K) of the thrust bushing, and replace with a new one if the wear limit is exceeded. Wear limit RHF5 4.07mm RHB51 3.65mm (b) Oil thrower 2 Measure the seal ring groove widths (G1) and (G2), and replace with a new one if the wear limit is exceeded. 4.07mm RHB31 Wear limits RHF5--- G1: 1.31mm, G2: 1.11mm RHB51--- G1: 1.31mm, G2: 1.11mm RHB31--- G1: 1.04mm, G2:
0.84mm (c) Thrust bearing 6 Measure the thrust bearing width (J), and replace with a new one if the wear limit is exceeded. Wear limit 3.98mm RHB31 RHF5 3.98mm RHB51 3.58mm (7) Floating bearing 5 1) Inspect the floating bearing for abnormal wear, discoloration or surface defect. Replace with a new one if defective. 2) Measure the inside diameter (C) and outside diameter(D). Replace the bearing if either wear limit is exceeded. Wear limits RHF5 Outside diameter (D): 12.31mm, Inside diameter (C): 8.04mm RHB51 Outside diameter (D): 12.31mm, Inside diameter (C): 8.04mm RHB31 Outside diameter (D): 9.93mm, Inside diameter (C): 6.29mm 132