Komatsu — 8.5.2 Inspection procedure

8. Turbochager (8) Bearing housing 15 1) Inspect the housing for cast surface exfoliation due to oxidation and degradation, dent or crack. 2) Inspect circlip 16 for chipping or crack, and replace with a new one if defective. 3) Measure the (B) and (F) portions of the bearing housing shown in the figure below. Replace with a new one if either wear limit is exceeded. Wear limit of bearing housing inside diameter (B) RHF5 12.42mm RHB51 10.01mm 12.42mm RHB31 Wear limit of turbine side seal ring inserting portion (F) RHF5 15.05mm RHB51 15.05mm RHB31 11.03mm (9) Seal plate 4 1) Inspect the seal plate for any contact trace, joint surface defect, dent or crack. Replace it if defective.

2) Measure the seal ring inserting dimensions (H1 and H2) on the compressor side, and replace the seal ring with a new one if either wear limit is exceeded. Wear limits RHF5 H1: 12.45mm, H2: 10.05mm RHB31 H1: 12.45mm, H2: 10.05mm RHB51 H1: 10.04mm, H2: 8.01mm (10) Seal rings Replace seal rings with new ones. (11) Inspect keep plates 10, 13 and bolts for any deformation, and replace defective parts with new ones. Also replace M3 Torx machine screws with new ones. 133