8. Turbochager 8.6 Reassembly Procedure 8.6.1 Preparation for reassembly 1) Prepare general tools, special tools, liquid gasket (Three Bond No.1207) and Locktite No.242 before reassembling the turbocharger. 2) Always replace the following parts with new ones: z Turbine side seal ring 1pc. z Compressor side seal ring(large) 1pc. z Compressor side seal ring(small) 1pc. z M3 machine screws 3pcs. z M3 machine screws 4pcs. 8.6.2 Reassembly (1) Floating bearing installation 1) Use the snap ring pliers and install inner circlip 16 on bearing housing 15. 2) Install floating bearing 5 in bearing housing 15. 3) Use the snap ring pliers and install outer circlip 16 on bearing housing 15. Note:
1) The circlip joint shall be positioned as shown in the figure at right above. The rounded side of the circlip shall face the bearing. 2) Apply lubricating oil on the floating bearing before reassembly. (2) Turbine shaft installation 1) Fit the seal ring onto turbine shaft 1. 2) Install heat insulating plate 20 on the turbine side of bearing housing 15. 3) Apply lubricating oil on the journal portion of the turbine shaft and insert the shaft from the turbine side of bearing housing 15. Note: Carefully operate so as not to damage the floating bearing by the turbine shaft. The seal ring joint shall be positioned on the lubricating oil inlet side after centering with the turbine shaft. 134