Komatsu — 2.2.6 Inspection every 1,000 hours or one year

2. Inspection and Adjustment [Informative: Fuel injection valve structure] (b) Spray pattern inspection After adjustment to the specified valve opening pressure, use a nozzle tester and check the spray pattern and seat oil-tightness. Seat oil tightness check z After injecting a few times, increase the pressure gradually. Hold the pressure for about 5 seconds at a little before the valve opening pressure of 1.96 MPa(20kgf/cm 2 ), and check to see that oil does not drip from the tip end of the nozzle. z If extreme oil leak from the overflow joint exists during injection by the nozzle tester, check after retightening. If much oil is leaking, replace the nozzle assembly. 44