2. Inspection and Adjustment Spray and injection states z Operate the nozzle tester lever at a rate of once or twice a second and check no abnormal injection. z If normal injection as shown below cannot be obtained, replace the fuel injection valve. z No extreme difference in angle( ) z No extreme injection angle difference( ) z Finely atomized spray z Excellent spray departure (c) Nozzle valve sliding test Wash the nozzle valve in clean fuel oil. Place the nozzle body vertically and insert the nozzle into the body to about 1/3 of its length. The valve is normal if it smoothly falls by its own weight into the body.
In case of a new nozzle, remove the seal peel, and immerse it in clean diesel oil or the like to clean the inner and outer surfaces and to thoroughly remove rust-preventive oil before using the nozzle. Note that a new nozzle is coated with rust-preventive oil and is pasted with the seal peel to shut off outer air. (d) Nozzle punch mark 45