Komatsu — 2.2.7 Inspection every 2000 hours or 2 years

2. Inspection and Adjustment 1) Before removing a fuel pump drive gear, make ID marks on the gearing part of the pump drive gear and the idle gear with paint and so on. 2) Make the mark-off line to the gear case precisely in accordance with the position of mark-off line of the fuel pump. 3) Before removing a fuel pump, put the standard mark of a sticker for fuel injection angle adjustment in accordance with the mark-off line of the fuel pump and paste it on the gear case. 4) Remove a fuel pump, and read the fuel injection angle recorded in that fuel pump.

5) Read the injection angle recorded on a reassembled fuel pump and calculate the difference from the injection angle of the disassembled fuel pump. (When re-installation does the same fuel pump, the angular difference is zero.) Fuel injection angle difference (cam angle) = (the fuel injection angle of a reassembled fuel pump) - (the fuel injection angle of a disassembled previous fuel pump) [NOTICE] Tell the fuel pump number, and inquire the injection angle of the pump when it is hard to find out.

6) Put the fuel pump on the gear case temporarily and install the drive gear on the cam shaft with checking the ID marks, which were put on the fuel pump drive gear and the idle gear at the time of the disassembling. Tighten the installation nut of a pump drive gear. 47 Model Tightening torque Nm(kgf・m) Lubricating oil application (thread portion, and seat surface) 3TNV82A TNV88 78 88 (8 9) Not applied 4TNV94L/98/106(T) 113 123 (11.5 12.5)