3. Troubleshooting Loosened connecting rod bolt Excessive gear backlash color White Starting failure Insufficient engine output Black 3.2 Quick Reference Table for Troubleshooting Exhaust White Fouled blower Waste gate malfunction Ordinary Reverse assembly of piston rings Worn intake/exhaust valve guide Worn floating bearing Engine starts Much Compression leakage from valve seat Blowout from cylinder head gasket Worn crankpin and journal bearing but stops soon. Exhaust smoke Little None Engine does not start.
Improper arrangement of piston ring joints Defective governor Trouble symptom Improper open/close timing of intake/exhaust valves Foreign matter trapped in combustion chamber Improper clearance of intake/exhaust valve Worn piston ring, piston or cylinder Seized crankpin metal or bearing Seizure of intake/exhaust valve Seized or broken piston ring Cause Engine system Turbocharger Trouble symptom Cause Starting failure Insufficient engine output Poor exhaust color High knocking sound during combustion Abnormal engine sound Uneven combustion sound Hunting Large engine vibration Difficulty in returning to low speed Excessive fuel consumption Lubricating oil Much blow-by gas Cooling water Air intake Exhaust temperature rise Corrective action Engine does not start.
Engine starts but stops soon. Exhaust color During work During idling During work Excessive consumption Dilution by fuel oil Mixture with water Low L.O. pressure Overheat Low water temperature Pressure drop Pressure rise Exhaust smoke Ordinary White Black White Black None Little Much Engine system Improper clearance of intake/exhaust valve Adjust the valve clearance. (See 2.2.6 in Chapter2.) Compression leakage from valve seat Lap the valve seat. (See 4.2.6 in Chapter4.) Seizure of intake/exhaust valve Correct or replace. Blowout from cylinder head gasket Replace the gasket. (See 4.2.2-11) in Chapter4.) Seized or broken piston ring Replace the piston ring.
(See 4.2.2-5)10) in Chapter4.) Worn piston ring, piston or cylinder Perform honing and use oversize parts. (See 4.4.5-1)4) and 4.4.6 in Chapter4.) Seized crankpin metal or bearing Repair or replace. Improper arrangement of piston ring joints Correct the ring joint positions. (See 4.4.4-6 in Chapter4.) Reverse assembly of piston rings Reassemble correctly. (See 4.4.4-6 in Chapter4.) Worn crankpin and journal bearing Measure and replace. (See 4.4.5-2) in Chapter4.) Loosened connecting rod bolt Tighten to the specified torque. (See 4.4.4-2 in Chapter4.) Foreign matter trapped in combustion chamber Disassemble and repair. Excessive gear backlash Adjust gear meshing.
(See 4.3.4-2 in Chapter4.) Worn intake/exhaust valve guide Measure and replace. (See 4.2.5-2) and 4.2.7 in Chapter4.) Defective governor Make adjustment. Improper open/close timing of intake/exhaust valves Adjust the valve clearance. (See 2.2.6-3) in Chapter2.) Turbocharger Fouled blower Wash the blower. Waste gate malfunction Disassemble and inspect. Worn floating bearing Disassemble and inspect.