4. Disassembly, Inspection and Reassembly of Engines Point9 [Disassemble] z Carefully remove the fuel injection valve so as not to leave the top end protector from being left inside the cylinder. [Reassemble] z Replace the fuel injection valve protector with a new one. Point10 [Disassemble] z When removing each intake/exhaust valve from the cylinder head, use a valve spring compressor (see 11.1-4 in Chapter 11) and compress the valve spring and remove the valve cotter.) z Keep each removed intake/exhaust valve after attaching a tag showing the corresponding cylinder No.
z If cotter burr is seen at the shaft of each intake/exhaust valve stem, remove it with an oilstone and extract the valve from the cylinder head. [Reassemble] z Replace the stem seal with a new one when an intake/exhaust valve is disassembled. z Carefully install each valve after oil application so as not to damage the stem seal. z Different stem seals are provided for the intake and exhaust valves. Do not confuse them since those for exhaust valves are marked with yellow paint. z After assembling the intake/exhaust valve, stem seal, valve spring, seat, and cotter, tap the head of the valve stem lightly for settling. z Do not forget to install the valve cap. 75