Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

4 Gauges 6LY3, 6CX, SY GEN III, alternate BY2 Unlimited Serial Gauge (i2200) Cut-outs and Mounting 3" Master Tachometer/Slave Speedometer Dimensions (in inches) Panel with Key Cut (recommended) Panel without Key Cut Note: Part number is on flat. (See “Template Section” for “actual size” image) 2" Minor Gauges Dimensions (in inches) Panel with Key Cut Panel without Key Cut +0.508mm -0.000mm (0 156in) Note: Part number is on flat. (See “Template Section” for “actual size” image) Panel Mounting Proximity: The minimum distances between gauges on a panel are:

3.90" (99.1 mm) center to center for 3-inch to 3-inch (76.2-76.2 mm); 3.25" (82.5 mm) center to center for 3-inch to 2-inch (76.2-50.8mm); 2.60" (66 mm) center to center for 2-inch to 2-inch (50.8-50.8 mm). Panel Thickness: 0.059" to 1" (1.5-25.4 mm); Keying available for panels 0.080" (2 mm) or greater. Spin nut fastening available for panels 0.50" (mm) or less. Roughness and Curvature: Panels will be flat and smooth to within +/- 0.020" (0.5 mm) within any 3" (76.2 mm) diameter. Panel Offset: Bezel offset from mounting surface is .065" (1.7 mm) typical. © 2011 Yanmar Marine International • Rev.

2.0 Yanmar Electronic Control Systems Technical Manual 4:23 84.84mm+0.508 (3.340in)–0.000 FLAT CUT-OUT, AS REQ’D 4.064mm±0.127mm (0.160in) 8.13 8mm+0.000mm 70in) -0.508mm 3.4 KEY SLOT, AS REQ’D 86.74 3.41 1mm+0.0000mm 5in) -0.0508mm (reco mmended) 4mm +0.000mm 0in) -0.508mm 50.03 (1.97 .3 .1 4m 0in KEY SLOT, AS REQ’D FLAT CUT-OUT, A 3.962mm ±0.127mm 07mm+0.0000mm 050in) -0.5100mm