Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

4 Gauges 6LY3, 6CX, SY GEN III, alternate BY2 Unlimited General The i2200 Series gauges receive all of their data and power from the CAN Bus. To properly specify and install the gauges it is important to consider both items. Data On CAN Bus systems one needs to keep in mind there are units on the CAN Bus that send data and units that receive data. Example : for the port oil pressure gauge to work there must be an item on the CAN Bus that sends port oil pressure so the port oil pressure gauge can receive and display the data. Only one device on the CAN Bus may send port oil pressure but many devices on the CAN Bus may receive the port oil pressure message.

Thus, when doing a setup or troubleshooting, it is important to think in terms of what information is on the CAN Bus and what unit put it there. Then go to what is on the CAN Bus to receive and display the information. A set of i2200 series gauges must have a tachometer and that tachometer must be connected to the CAN Bus. The tachometer listens to the CAN Bus and picks off just the data that is appropriate for an engine that is specified by the tachometer part number. Thus a port tachometer picks up port RPM, and all other port engine parameters that any two inch gauge may need.

The gauges may receive oil pressure, coolant water temperature, coolant water pressure, boost pressure, voltage, and trim assuming the data is on the CAN Bus. Each tachometer (regardless of its part number and its port, center, or starboard assignment) also picks speed and all fuel levels off the CAN Bus. Again, this assumes there is a device on the CAN Bus that sends out this data. The tachometer uses the RPM information for its display and passes the remaining information that it receives from the CAN Bus to its associated gauges. Engine specific data as well as speed and fuel levels are sent to the gauges connected to a specific tachometer.

The data from the tachometer to its associated gauges are in SAE 1708 format. In the example above, we have selected a port tachometer, a speedometer, and four 2” gauges. Since it is a port tachometer it will display port engine RPMs. It will also pass port engine parameters like oil pressure, engine coolant temperature, port voltage, etc. to the 2” gauges. Since the speed reading on the CAN Bus does not have a port, center, or starboard designator, all tachometers pass the speed reading through so a speedometer may be connected to any tachometer. All fuel level information is also sent to the 2” gauges.

This allows the connection of an assortment of fuel gauge setups to handle the extensive variety of tank arrangements encountered. © 2011 Yanmar Marine International • Rev. 2.0 4:24 Yanmar Electronic Control Systems Technical Manual