Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

4 Gauges 6LY3, 6CX, SY GEN III, alternate BY2 Unlimited Fuel Level The NMEA 2000 ® standard has provisions to handle a wide variety of fuel tank designations. This is required as so many tank combinations are used in boats. The standard uses a term called “Instance” to address specific tanks. This is simply a line in an address much like we put on an envelope. A fuel level sender is measured by an electronic box and a reading is obtained. The reading usually starts out in analog form and is then converted to a digital message. To send the message onto the CAN Bus a designator (address) needs to be assigned.

The first part of the designator is called a PGN and simply states this is a Fluid Level. The second part of the address indicates it is fuel. The third part of the address is called an “Instance” and identifies a specific tank. For more information see the “Section 8 - Networks” in this manual. Any number of devices may measure a tank sender and place information on the CAN Bus. The common case on a typical dual engine application is the port tank will go to the port engine interface and the starboard tank to the starboard engine interface. This will result in both port and starboard fuel levels being sent out on the CAN Bus.

The port tank information will become NMEA 2000 ® instance 0 and will be called Yanmar instance “Primary.” The starboard tank information will become NMEA 2000 ® instance 1 and will be called Yanmar instance “1.” If a third tank is present, it connects to the port engine interface fuel 2 input that will place its readings on the CAN Bus as NMEA 2000 ® instance 2 which will become Yanmar instance “2.” This input will read out on auxiliary 2 gauge. The level 2 input on the starboard engine interface sends its signal to the auxiliary 3 gauge. Note: Early 6LY3 interfaces with software before software revision 2.03 only support one fuel level. Yanmar fuel gauges work as follows:

Each tachometer in the system decodes all of the fuel gauge readings on the CAN Bus. Thus the primary gauge, instance 1, instance 2, and instance 3 readings are decoded by each and every tachometer. This means that any fuel gauge can be connected to any tachometer, and up to four fuel gauges with different instances may be connected to any tachometer. The primary fuel gauge will always show the port (or single) tank. The instance 1 gauge will always show the starboard (or first auxiliary) tank. The instance 2 gauge will always show the second auxiliary tank, and the instance 3 gauge will always show the third auxiliary tank. This table shows some examples:

© 2011 Yanmar Marine International • Rev.

2.0 Yanmar Electronic Control Systems Technical Manual 4:25 Tanks Input Device NMEA 2000® Instance Yanmar Gauge Designator Tank Number One Tank Engine Interface - Fuel 1 0 Primary 1 Two Tanks Port Port Engine Interface - Fuel 1 0 Primary 1 Starboard Starboard Engine Interface - Fuel 1 1 Auxiliary 1 2 Three Tanks Port Port Engine Interface - Fuel 1 0 Primary 1 Starboard Starboard Engine Interface - Fuel 1 1 Auxiliary 1 2 Center Port Engine Interface - Fuel 2 2 Auxiliary 2 3 Four Tanks Port Port Engine Interface - Fuel 1 0 Primary 1 Starboard Starboard Engine Interface - Fuel 1 1 Auxiliary 1 2 Tank 3 Port Engine Interface - Fuel 2 2 Auxiliary 2 3 Tank 4 Starboard Engine Interface - Fuel 2 3 Auxiliary 3 4