Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

5 Control Heads Installation Instructions 1. Starting with either port or starboard control, locate the desired position of center of handle and cut a 1-3/4 inch (45 mm) diameter through hole in the mounting surface. 2. Remove the spanner nut from the front of the control. Insert the controls threaded flange through the 1-3/4 inch hole from the inside. Re-install the spanner nut from the outside (hand tight only). 3. The control can now be rotated and positioned so that the drag adjustment screw is accessible from inside for future adjustments.

Note that since the control handle can be mounted in any position about the axis (in 10 degree increments), there is no orientation requirement for the controls. 4. Make any necessary adjustments to plum and square by shimming between the inside installation surface and the face of the mounting flange. 5. When satisfied with position and alignment, tighten the spanner nut. 6. Using the holes in flange as a guide, match drill (from inside of boat) the eight flange mounting holes. Use pilot hole for the 1/4 inch dia. mounting screws (provided). Drill pilot holes to a maximum depth of 1/2 inch (13 mm). Caution: Do not drill through outer surface of the console.

Since conditions vary widely, it may be necessary to vary the hole size to suit a particular application. 7. Install the eight mounting screws provided. 8. From outside, install woodruff key into shaft and mount center splined hub (part of handle assembly) and tightening set screw securely. Install handle onto hub using set screw provided. The control handle can be mounted in any position about the axis (in 10 degree increments). Choose a position that is both safe and convenient to the boat operator. Repeat steps 1 through 8 for the second control.

Mounting the Operators Panel (CP1100 or CP1200) Determine a Proper Mounting Location The CP1100 or CP1200 Operator Panel is designed to be mounted on flat surfaces convenient for both operation and installation. The panel is designed to mount on surfaces from 1/4 inch (6 mm) to 1 inch (25 mm) thick with the hardware provided. Mount the Operator Panel NOTICE Before using a template from this manual, measure it to be certain it is to scale. Mount the CP1100 or CP1200 Operator Panel Template from “Section 14 - Mounting Templates,” in this manual, to the chosen mounting surface. 1. Mark the mounting surface for hole placement using the template.

Drill two mounting holes (CP1100) OR four mounting holes (CP1200) and switch center hole. 2. Secure operator panel to the mounting surface with four #10 x 1-1/2 inch (38 mm) long mounting screws, washers, and locking nuts provided. © 2011 Yanmar Marine International • Rev. 2.0 5:20 Yanmar Electronic Control Systems Technical Manual