Yanmar — Yanmar Electronic Control System Technical Manual for Classic, BY2, 6LY3, 6CX, and SY GEN III Series Engines

5 Control Heads Control Head Drag and Detent Adjustment Each CH1900 control has been factory pre-set for comfortable detent and drag operation. However, if an operator desires a different “feel” to the controls, adjustments can be made as follows: Control Lever Drag: NOTICE Turning the adjustment screw too tightly can damage the drag adjustment. The drag adjustment screw is located on the side of each control head. Adjustment requires a 5/32” hex allen wrench. Drag is increased by rotating the screw clockwise, and decreased with counter clockwise rotation. Be aware that noticeable drag changes are made with relatively small adjustments to the screw.

It is recommended that adjustments be made by turning the screw in small increments (no greater than 1/4 turn) and then feeling the resultant change at the handle. Drag adjustment screw The detent adjustment screw is located on the inside end of each control head and requires a flat screwdriver for adjustment. Detent firmness is increased by rotating the screw clockwise, and decreased with counterclockwise rotation. It is recommended that adjustments be made by turning the screw in small increments (no greater than Ѕ turn), then feeling the resultant change at the handle. Detent adjustment screw Note:

After all controls and system components have been mounted and interconnected, the system must be Setup to agree with the engines, transmissions, and operators preferences. For calibration, feature selection, and system operation, refer to the Electronic Control System Installation Manual for the specific engine. © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 5:21