5 Control Heads Single Lever - Dual or Triple Engine Controls for Single Function Controls CH4400 or CH5600 (see page 5:30) Port Lever With the system OFF (no power on the CAN Bus) press and hold the PORT Neutral button on the control head and turn the power ON. The port neutral lamp will blink. Move the Port lever to the FULL FORWARD position and press the SELECT button. The select lamp will turn on. Move the Port lever to the FORWARD IDLE position. The port neutral lamp will blink. Press the SELECT button. The select lamp will turn on. Move the Port lever to the NEUTRAL position. The port neutral lamp will blink. Press the SELECT button. The select lamp will turn on.
Move the Port lever to the REVERSE IDLE position. The port neutral lamp will blink. Press the SELECT button. The select lamp will turn on. Move the Port lever to the FULL REVERSE position. The port neutral lamp will blink. Press the SELECT button. The select and port neutral lamps will both blink indicating the process is complete. Turn the power OFF to exit the port calibration process. Starboard Lever With the system OFF (no power on the CAN Bus) press and hold the STARBOARD Neutral button on the control head and turn the power ON. The starboard neutral lamp will blink. Move the Starboard lever to the FULL FORWARD position and press the SYNC button. The sync lamp will turn on.
Move the Starboard lever to the FORWARD IDLE position. The starboard neutral lamp will blink. Press the SYNC button. The sync lamp will turn on. Move the Starboard lever to the NEUTRAL position. The starboard neutral lamp will blink. Press the SYNC button. The sync lamp will turn on. Move the Starboard lever to the REVERSE IDLE position. The starboard neutral lamp will blink. Press the SYNC button. The sync lamp will turn on. Move the Starboard lever to the FULL REVERSE position. The starboard neutral lamp will blink. Press the SYNC button. The sync and starboard neutral lamps will both blink indicating the process is complete. Turn the power OFF to exit the starboard calibration process.
© 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 5:23